![]() ![]() This is super easy and very straightforward. Add a 1/4 jack to allow connection to a cab. Perhaps it makes sense to experiment with different values if you have kept the final gain stage (read below), but without it, you get a nice percussive and super-rich sound that is almost JazzChorus-like. Something especially evident in harmonics and pick attack. Without it, when the boost is on, the sound gets a bit harsh. It rounds the sound a lot, and it kills lots of clarity. This cap acts as a low-pass filter on the final stage. The only issue with it, is that when the boost is on and the gain is set high, the amp is VERY loud. Just snip the LEDs and you immediately get rid of that "bees in a can" sound when the boost is on. This is very common mod, and the first one that anyone should do. So here is the list of my mods, gathering info from around the internet, plus results so far. My goal is to have a nice platform to use with my pedals, but mostly diy itself since I have other amps. ![]() The schematic has been around for almost a decade, but there still might be things that need to be fixed. It's easy to lift pads if you are not careful. Keep in mind that the pcb is crappy though. Plus it's a DIYer's dream, being a full old-school circuit with a transformer PSU and all through-hole parts. With a "few" mods and a cab it sounds great. That's my second ongoing small guitar amp project after the Fender Champion 40. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |